This Stinson Reliant is currently on display in the National Postal Museum.
The mail container is being readied for pick-up.
This map shows where the airmail service was offered.
Stinson Reliant monoplanes were used in 1939 to test a unique airmail service for communities that did not have landing fields.
Mail was loaded into the container on the right which was then placed on top of a contraption resembling a goal post. As the pilot
guided the airplane down, the flight officer lowered a grappling hook to snag the container. Mail destined for the community was
then dropped from the plane onto the airfield. The technique was modeled on the Railway Mail Service's "mail-on-the-fly" pickups.
In the 1930s, postal officials decided to test the feasibility of inaugurating airmail service in areas without adequate railway or
highway mail links. Unfortunately, the towns which needed this type of service usually did not have adequate landing fields for
Although a low-flying airplane could easily dump a sack of mail onto the ground, the difficult part would be getting
ground mail into the moving plane. The Railway Mail Service's successful on-the-fly mail exchange system provided
the inspiration for an aviation experiment. Mail would be "caught" by a plane flying overhead and reeled up into the
plane. Of course, catching the mail was not going to be easy.
An airplane outfitted with a hook flew over the posts, and successfully hooked the mail and reeled it in. At
the top of each pole was a small direction flag, which showed the pilot the prevailing wind direction; and a
pincer, which was used to keep the 60 foot long noose attached to the mail canister in place.
Postal officials realized that throwing the mail out of a passing airplane wasn't going to be easy either. A
simple mail sack wasn't going to be sufficient because it would be prone to fall in a random direction
depending on the wind. A weighted holder was needed. But, if the canister was too heavy it might cause
significant damage if it hit something when it fell. Then too, the canister holding the mail had to be able
to survive repeated drops. Various different styles of receptacles were tested. Ultimately a hollow rubber
design, resembling the nose cone of a rocket, was chosen.
The plane that was initially used was a single engine Stinson aircraft, capable of operating at speeds of
approximately 150 miles an hour. The crew consisted of the pilot and a flight officer who worked the pick-up
mechanism, making the mail exchange. To deliver the mail, the flight officer lowered the mail container out of
the bottom of the aircraft through a special opening. Just before reaching the poles he released the canister.
Almost at the same instant an arm was lowered. The grappling hook snagged the hanging mail pouch then slid down
the arm and caught the noose. Once the catch was made the flight officer activated the winding mechanism to reel
the mail canister into the plane.
The method of exchanging mail in transit was adopted for experimental airmail routes in Ohio, New York, Pennsylvania,
Kentucky, and West Virginia. In all, more than 150 post offices were served. This style of pick up and delivery
service began on May 12, 1939. The mail contractor that used the service was All American Airways Company. (Which
later became known as Allegheny Airlines, and is now USAir. )The experimental routes covered 1,040 miles. During the
first year of operation, more than 23,000 pick ups were made, amounting to 75,000 pounds of mail. The service was used
in those areas for about ten years.
The Stinson airplane is flying with its hook down, to pick up the mail in the container strung between hooks.
The mail was placed in a rubber container that was suspended between a pair of 15-foot-high posts.